Steel Folding Security Gates

Double Gates

1. Two gate webs
2. Two "L" brackets per gate.
3. Two large washers for bearings
4. One "H" bracket
5. Center drop pin 
6.  Additional lockable drop pins in the center of each web on 14' and wider gates

1. Gates over 20 feet wide will be provided in four webs. Two pieces will bolt  together to become one half of the gate. A caster and a drop pin will be provided where the gates are bolted together.
2. If no holes can be drilled into the floor for a bottom mount, then 4 "L" brackets are provided. Two for the bottom and two for the top mounts - Washers are not provided for this exception.
3. If the center of the gate does not reach the top of the opening, a "horseshoe" bracket is welded to the leading edge of one half of the gate. The other gate fits into this, and no "H" bracket is included.
4. Two 1 1/2" angles for center rail extensions may be provided when specified. An "H" bracket is provided with this exception.
5. If gates are to be used as a traffic barrier only, then there may not be a drop pin in the center of the webs, for the wide gates. This is subject to specifications.

1. One gate
2. One "L" bracket
3. One locking bar
4. One large washer for bearing
5. Center drop pin (lockable) in bottom of each web over 6 feet wide.
6. See exceptions if other options specified on order or any of the above not included

Optional Equipment
Single Gates

1. Two webs provided for gates over 10' wide. This set bolts together to become one single gate with a locking bar. A drop pin and caster are provided at the split point.
2. Two "L" brackets are provided where hole cannot be drilled into floor for mounting bottom of gate. No washer is provided with this.
3. If traffic barrier is use of gate, no drop pin in center of gate is provided - subject to specification.
4. Optional hinge bar mount is attached to gate if specification states it is necessary. This exception is used where appearances are important, as it is a better-looking system than the industrial "L" bracket type. No washer or "L" bracket provided with this option.